2025 Toyota Grand Highlander Reliability Score & Common Problems

Inconsistently but on numerous occasions, this vehicle has experienced harsh shifting, hesitation, or jerking during low-speed acceleration (e.g., 20-40 mph) or gear engagement. This was a known and reported issue with the 2024 model for which Toyota provided a fix. They have not provided one for the 2025 models. This issue is a safety risk while driving because with the surge you feel you must quickly let off the pedal, and with the hesitation you let off the brake indicating you will move forward yet the vehicle doesn’t accelerate.

The contact owns a 2025 Toyota Grand Highlander. The contact received notification of NHTSA Campaign Number: 25V744000 (Back Over Prevention); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted and diagnosed the vehicle and determined that the camera had failed, and that the contact would be notified when the remedy was available. The contact stated that after leaving the vehicle with the dealer, the back over camera started to fail. The back over prevention camera no longer switched the screen for the camera while in reverse, but remained on the home screen or radio instead. The contact had not heard from the dealer regarding the parts availability for the repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 29,000.

2025 Toyota Grand Highlander Hybrid AWD, with about 16000 miles. While driving, the brakes failed. The brakes would only work if the pedal was pushed all the way to the floor. A "Low Brake Power" warning light came on the dash. The following warnings came on at the same time. Parking Brake System, Advanced Ultrasonic Detection, Vehicle Stability Control, Check Engine, Smart Stop System, Brake System, Electronically controlled Brake, Secondary Collision Brake, Anti-lock Brake System. I was lucky to have been traveling on a road that was not busy and was traveling at less than 30 mph very close to my home. Had I been driving on the interstate, on a busy road, or near pedestrians, the event could have injured or killed myself, my family, or others. The car was towed into the dealership. The dealership said that the issue was not current and the car operated normally when after it was towed in. The following DTC codes where present (P05E000, P05E062). This indicates an issue in wiring or brake pedal stroke sensor. They suspect its an intermittent issue with the sensor. The sensor was replaced (P/N, 89510-0R010 and 62112-0E040-C1). They also said the car battery was low and replaced it (P/N 00544-H5061-540). The dealership said that they would send the affected part to Toyota for inspection, but I have not heard anything back. The dealership experience was poor (Mark Jacobson Toyota, Durham, NC).

The vehicle takes an excessively long time to make heat, I know NHTSA only has requirements related to defrosting the windshield and it's clear Toyota is aware of the heating issue because they added an electronic defrost to be able to pass the defrost test. The vehicle when it is less than 20f outside takes 40+minutes to warm the cabin to a reasonable temperature. The dealership let the vehicle warm up in their 80deg F shop and said it took 20minutes to get heat out of the vents and claimed that this was normal behavior. I have owned several new cars and also work as an engineer in testing so I've driven countless new vehicles to do various tests and have never had it even take 20 minutes to have heat in a vehicle.

The contact owns a 2025 Toyota Grand Highlander with an Evenflo Revolve 360 Slim car seat, Model Number: 36812470A, Manufactured Date: December 12, 2022, installed in the vehicle. The contact received notification of NHTSA Campaign Number: 25C010000 (Child Seat). The contact stated that while driving at an undisclosed speed with the child secured in the car seat, the contact became aware that there was an object in the child’s mouth. The contact pulled over to the side of the road and removed a foam piece from the child's mouth. The contact inspected the car seat and became aware that the foam was from the headrest. Medical attention was not needed. The manufacturer was not notified of the failure, but the contact stated that the manufacturer mailed tape to cover the exposed areas of the car seat.